+31 53 850 6850
EUR
My Account
Cart: 0 item - €0.00
2-Pack T8050 CE Chip Pack
€245.00

Availability: In stock

Pack of 2 long CE chips for the EOF Kit 9015.
Share this product on:
Pack of 2 long CE chips for the EOF Kit 9015. The chip can be used for capillary electrophoresis.The CE chip T8050 has a double T injection and a separation length of 80 mm. The channels are 50 µm wide and 20 µm deep.
Product CodeCH_T8050_PACK
Number of chips per pack2
Distance between channel and top surface1100 µm
Distance between channel and bottom surface680 µm
Channel locationbottom layer
Total chip thickness1800 µm
Chip size90 mm x 15 mm
Channel width50 µm
Channel height20 µm
Internal Volumechannels only: 79 nL / holes only: 12.5 µL
Number of Inlets3
Number of outlets1
Inlet/outlet hole sizes on top of the chip2.50 mm
Inlet/outlet holes size at channel1.55 mm
Optical propertiesOptical clear view from all sides
Supplied in Fluidic slide?No
Material chipBorosilicate
Material black cartridgeN/A

Write Your Own Review

You're reviewing: 2-Pack T8050 CE Chip Pack

How do you rate this product? *

 1 star2 stars3 stars4 stars5 stars
Quality

My chips are clogged, how do I prevent this?

Have a look at our clogging prevention guide

There's no flow in my setup. How do I fix this?

Is your setup clogged with dirt or fully blocked?
Chips can get clogged, for example when they’ve been used before and have not been cleaned the right way. If your chip is clogged with dirt, check our document on the prevention of clogging and/or read the answer to question number one on this page (regarding the cleaning of chips). Clogged chips often do let some flow through the chip, which makes it easier to identify the issue as clogging. If there is no flow at all it’s more likely that the flow path is not connected correctly.

Pinpoint the issue
We recommend walking through the full track of the fluid flows: check if your syringe or pump is not blocked, if your tubing is actually hollow and if your filters let fluids pass through. Then check if your chip has inlet and outlet holes and if these are positioned so that the fluids can go through the chip. The easiest way to do this is to disassemble the setup and check if fluids come out of the pump, then connect the tubing and check if fluids can come through. Keep on adding parts and checking if the fluids go through. This way you can pinpoint the problem.

If the problem remains
If the problem cannot be solved after following the above-mentioned steps, then take some pictures or make a short movie of your setup and send this, together with the description or name of your chip, to Micronit. We will gladly assist you in identifying the issue.