+31 53 850 6850
EUR
My Account
Cart: 0 item - €0.00
10- Pack Sheet nozzle with 2 inlet ports & hydrophobic coating
€1,250.00

Availability: In stock

10-pack of spray nozzles able to make a thin-film liquid sheet.
Share this product on:

10-pack of spay nozzles able to make a thin-film liquid sheet. The spray nozzles are manufactured from borosilicate glass. The nozzles are able to create free-flowing, sub-micron, liquid sheets which are two orders of magnitude thinner than anything previously reported. Optical, infrared, and X-ray spectroscopies are used to characterize the sheets, which are found to be tunable in thickness from over 1 μm down to less than 20 nm, which corresponds to fewer than 100 water molecules thick. At this thickness, aqueous sheets can readily transmit photons across the spectrum, leading to potentially transformative applications in infrared, Xray, electron spectroscopies and beyond. Their use is demonstrated at free-electron laser and synchrotron light sources.

Have a look at this Nature communications article describing this chip:
Koralek, Jake D., et al. "Generation and characterization of ultrathin free-flowing liquid sheets." Nature communications9.1 (2018): 1353.

Product Code00957
Number of chips per pack10
Distance between channel and top surface365-375µm
Distance between channel and bottom surface365-375µm
Channel locationbottom & top layer
Total chip thickness800µm
Chip size17mm x 6mm
Channel widthchannel 1: 25µm and channel 2: 55µm
Channel heightchannel 1: 20µm and channel 2: 50µm
Internal Volume-
Number of Inlets2
Number of outlets1
Inlet/outlet hole sizes on top of the chip400
Inlet/outlet holes size at channel200
Optical propertiesClear sight from top and bottom
Supplied in Fluidic slide?No
Material chipBorosilicate glass
Material black cartridgen.a.

Write Your Own Review

You're reviewing: 10- Pack Sheet nozzle with 2 inlet ports & hydrophobic coating

How do you rate this product? *

 1 star2 stars3 stars4 stars5 stars
Quality

My chips are clogged, how do I prevent this?

Have a look at our clogging prevention guide

There's no flow in my setup. How do I fix this?

Is your setup clogged with dirt or fully blocked?
Chips can get clogged, for example when they’ve been used before and have not been cleaned the right way. If your chip is clogged with dirt, check our document on the prevention of clogging and/or read the answer to question number one on this page (regarding the cleaning of chips). Clogged chips often do let some flow through the chip, which makes it easier to identify the issue as clogging. If there is no flow at all it’s more likely that the flow path is not connected correctly.

Pinpoint the issue
We recommend walking through the full track of the fluid flows: check if your syringe or pump is not blocked, if your tubing is actually hollow and if your filters let fluids pass through. Then check if your chip has inlet and outlet holes and if these are positioned so that the fluids can go through the chip. The easiest way to do this is to disassemble the setup and check if fluids come out of the pump, then connect the tubing and check if fluids can come through. Keep on adding parts and checking if the fluids go through. This way you can pinpoint the problem.

If the problem remains
If the problem cannot be solved after following the above-mentioned steps, then take some pictures or make a short movie of your setup and send this, together with the description or name of your chip, to Micronit. We will gladly assist you in identifying the issue.